Additional information
| HSIN CODE :- | 85381010 |
|---|
Related products
MQ6 – LPG Propane Gas Sensor Module
₹120.00Add to cartThis is a very easy to use low cost semiconductor Gas sensor Module with analog and digital output. This module uses MQ6 LPG gas sensor as a gas sensing element. It requires no external components just plug in VCC & ground pins and you are ready to go.
For Digital output the threshold value can be easily set by an on-board potentiometer. Using this module you can easily interface MQ6 LPG gas Sensor to any Microcontroller, Arduino or even Raspberry Pi.
MAX30100 Pulse Oximeter Heart Rate Sensor Module
₹160.00Add to cartMAX30100 is an integrated pulse oximeter and heart-rate monitor sensor solution.?It?s an optical sensor that derives its readings from emitting two wavelengths of light from two LEDs ? a red and an infrared one ? then measuring the absorbance of pulsing blood through a photodetector. This particular LED colour combination is optimized for reading the data through the tip of one?s finger.?It is fully configurable through software registers and the digital output data is stored in a 16-deep FIFO within the device.It has an I2C digital interface to communicate with a host microcontroller.
12V DC 1/2 inch Electric Solenoid Water Air Valve Switch (Normally Closed)
₹320.00Add to cart12V DC Solenoid Water Air Valve Switch?(Normally Closed)?1/2 controls the flow of fluid (liquid or air) and acts as a valve between high-pressure fluid! This liquid valve would make a great addition to your robotic gardening project.?There are two (Nominal NPT) outlets.?Normally, the valve is closed. When a 12V DC supply is applied to the two terminals, the valve opens and water can push through.
The valve works with the solenoid coil which operates electronically with DC 12 volt supply. As it is a normally closed assembly,?it opens the flow of fluids as soon as it is powered ON and stops/blocks the flow when the supply voltage removed.
