Subtotal: ₹617.00
₹20.00
The LM7805 series of three terminal positive regulators are available in the TO-220 package and with several fixed output voltages, making them useful in a wide range of applications. Each type employs internal current limiting, thermal shut down and safe operating area protection, making it essentially indestructible. If adequate heat sinking is provided, they can deliver over 1A output current. Although designed primarily as fixed voltage regulators, these devices can be used with external components to obtain adjustable voltages and currents.
Available on backorder
Features:-
* Output Current up to 1A
* Output Voltages of 5, 6, 8, 9, 12, 15, 18, 24
* Thermal Overload Protection
* Short Circuit Protection
* Output Transistor Safe Operating Area Protection
Specification:-
| Symbol | Parameter | Min | Type | Max | Units |
| VO | Output Voltage | 4.8 | 5 | 5.2 | V |
| Regline | Line Regulation | 4 | 100 | m V | |
| Regload | Load Regulation | 9 | 100 | m V | |
| IQ | Quiescent Current | 5 | 8 | ?C | |
| RR | Ripple Rejection | 62 | 73 | d B |
| Weight | 10 kg |
|---|---|
| Dimensions | 60 × 50 × 10 cm |
| HSIN CODE :- | 85369090 |
The 4mm LDR Sensor Photoresistor Photo Cell 5-10K GL4516 is an electronic component that detects and measures light levels. It operates using the active voice, meaning it actively senses light rather than being passively affected by it. The sensor is equipped with a 4mm diameter photoresistor, which is a type of resistor that changes its resistance based on the amount of light that falls on it. This resistance range is between 5-10K ohms.
MAX30100 is an integrated pulse oximeter and heart-rate monitor sensor solution.?It?s an optical sensor that derives its readings from emitting two wavelengths of light from two LEDs ? a red and an infrared one ? then measuring the absorbance of pulsing blood through a photodetector. This particular LED colour combination is optimized for reading the data through the tip of one?s finger.?It is fully configurable through software registers and the digital output data is stored in a 16-deep FIFO within the device.It has an I2C digital interface to communicate with a host microcontroller.
ECG Monitor Sensor Module is based on AD8232 Analog Device IC. This is a cost-effective ECG Sensor used to measure the electrical activity of the heart. This electrical activity can be charted as an ECG or Electrocardiogram and output as an analog reading. ECGs can be extremely noisy, out AD8232 Single Lead Heart Rate Monitor acts as an op amp to help obtain a clear signal. This sensor can be connected to an Arduino/Raspberry Pi, etc. Sample codes are easily available on the internet.
