

I2C Module
₹60.00 Original price was: ₹60.00.₹50.00Current price is: ₹50.00.
In stock (can be backordered)
Related products
Rain Drop Sensor Module
₹50.00Original price was: ₹50.00.₹42.00Current price is: ₹42.00.Add to cartThe Raindrops Detection sensor module is used for rain detection. It is also for measuring rainfall intensity. Rain sensor can be used for all kinds of weather monitoring and translated into output signals and AO.
Raindrops Detection Sensor Module Rain Weather Module for Arduino, etc. Rain sensor can be used to monitor a variety of weather conditions and turned into several fixed output signal and Analog output.
It includes a printed circuit board (control board) that ?collects? the raindrops. As raindrops are collected on the circuit board, they create paths of parallel resistance that are measured via the op-amp. The lower the resistance (or the more water), the lower the voltage output. Conversely, the less water, the greater the output voltage on the analog pin. A completely dry board, for example, will cause the module to output 5V.
Add to WishlistAlready In WishlistAdd to WishlistMQ3 Alcohol Gas Sensor Module
₹110.00Original price was: ₹110.00.₹102.00Current price is: ₹102.00.Add to cartThis is a very easy to use low cost semiconductor Gas sensor Module with analog and digital output. This module uses MQ3 Alcohol gas sensor as a alcohol gas sensing element. It requires no external components just plug in Vcc & ground pins and you are ready to go.
For Digital output the threshold value can be easily set by an on-board potentiometer.? Using this module you can easily interface MQ3 Alcohol sensor to any Microcontroller, Arduino or even Raspberry Pi.
Add to WishlistAlready In WishlistAdd to Wishlist4mm LDR Sensor Photoresistor Photo Cell 5-10K GL4516 with Wire
₹10.00Original price was: ₹10.00.₹8.00Current price is: ₹8.00.Add to cartThe 4mm LDR Sensor Photoresistor Photo Cell 5-10K GL4516 is an electronic component that detects and measures light levels. It operates using the active voice, meaning it actively senses light rather than being passively affected by it. The sensor is equipped with a 4mm diameter photoresistor, which is a type of resistor that changes its resistance based on the amount of light that falls on it. This resistance range is between 5-10K ohms.
Add to WishlistAlready In WishlistAdd to Wishlist

