Related products
Female To Male Jumper Wires
₹70.00Add to cartThis cable is an electrical wire or group of them in a cable with a connector or pins at each end, which is normally for interconnecting the components of a bread board or other prototype or test circuit, internally or with other equipment or components, without soldering.
NE555 Timer IC DIP-8 Package
₹20.00Add to cartThe NE555 IC devices are precision timing circuits capable of producing accurate time delays or oscillation. In the time delay or monostable mode of operation, the timed interval is controlled by a single external resistor and capacitor network. In the a stable mode of operation, the frequency and duty cycle can be controlled independently with two external resistors and a single external capacitor. The threshold and trigger levels normally are two-thirds and one-third, respectively, of VCC. These levels can be altered by use of the control-voltage terminal. When the trigger input falls below the trigger level, the flip-flop is set, and the output goes high. If the trigger input is above the trigger level and the threshold input is above the threshold level, the flip-flop is reset and the output is low.
USB A To B Cable – Cable for Arduino
₹40.00Add to cartThis is a Cable for Arduino UNO/MEGA (USB A to B)-1M, you can use it to connect??Arduino Uno?, ?Arduino Mega 2560??or any board with the USB female A port of your computer.?Cable length is approximately 30 cm. Cable colour and shape may vary slightly from an image as our stock rotates.
This USB cable for Arduino is a standard-issue USB 2.0 cable. the kind that?s usually used for printers,?Arduino, etc. Compatible with most SFE designed USB boards as well as USB Arduino boards like the Uno.
