Additional information
| HSIN CODE :- | 85381010 |
|---|
18.2% OFF
Joystick Module
Original price was: ₹55.00.₹45.00Current price is: ₹45.00.
In stock (can be backordered)
Related products
-
RC522 RFID reader
Original price was: ₹110.00.₹90.00Current price is: ₹90.00.Add to cartRC522: 13.56MHz RFID Reader/Writer with Cards The kit includes a 13.56MHz RF reader/writer module that uses an RC522 IC along with two S50 RFID cards. The MF RC522 is an extremely integrated transmission module that operates at 13.56 MHz for contactless communication. RC522 is compatible with MIFARE/ISO 14443A mode.
-
4mm LDR Sensor Photoresistor Photo Cell 5-10K GL4516 with Wire
Original price was: ₹10.00.₹8.00Current price is: ₹8.00.Add to cartThe 4mm LDR Sensor Photoresistor Photo Cell 5-10K GL4516 is an electronic component that detects and measures light levels. It operates using the active voice, meaning it actively senses light rather than being passively affected by it. The sensor is equipped with a 4mm diameter photoresistor, which is a type of resistor that changes its resistance based on the amount of light that falls on it. This resistance range is between 5-10K ohms.
-
Rain Drop Sensor Module
Original price was: ₹50.00.₹42.00Current price is: ₹42.00.Add to cartThe Raindrops Detection sensor module is used for rain detection. It is also for measuring rainfall intensity. Rain sensor can be used for all kinds of weather monitoring and translated into output signals and AO.
Raindrops Detection Sensor Module Rain Weather Module for Arduino, etc. Rain sensor can be used to monitor a variety of weather conditions and turned into several fixed output signal and Analog output.
It includes a printed circuit board (control board) that ?collects? the raindrops. As raindrops are collected on the circuit board, they create paths of parallel resistance that are measured via the op-amp. The lower the resistance (or the more water), the lower the voltage output. Conversely, the less water, the greater the output voltage on the analog pin. A completely dry board, for example, will cause the module to output 5V.
